Multitech ProxyServer MTPSR1-202ST User Manual page 22

ProxyServer User Guide
13. The ISDN Configuration Default Parameters dialog box is displayed.
In the Default Configurations window, click on the default configurations supplied by your local
ISDN service provider. Refer to your entry in Network Switch Type in Before You Start Loading
Your Software in this chapter.
14. Place your cursor in the ISDN Dial Number field and enter the telephone number supplied by
your Internet service provider. The telephone number can be a standard local number or it can
include a long distance prefix.
Note: Some Internet service providers require only that you enter the phone number you call for
ISDN service.
15. If the phone number is all your Internet service provider requires, click the OK button and go to
step 21 to continue loading your software. However, if your Internet service provider requires that
you enter additional parameters, continue with step 16.
16. Click the Data TEI field in the Network Parameters group. Refer to your Data TEI entry in the
Network Configuration section in Before You Start Loading Your Software. If the Data TEI is
different, click the drop-down list arrow and click the selection that corresponds to the Data TEI
supplied by Internet service (i.e., Disabled, Auto TEI, or zero to 63).
17. Click the Voice TEI field in the Network Parameters group. Refer to your Voice TEI entry in the
Network Configuration section in Before You Start Loading Your Software. If the Voice TEI is
different, click the drop-down list arrow, then click the selection that matches the Voice TEI
supplied by your Internet service (i.e., Disabled, Auto TEI, or zero to 63).
18. If your ISP or Remote Access Server (RAS) uses Point-to-Point Protocol (PPP), click the User
Name field in the Authentication group and enter your user name. If SLIP protocol is used by
your ISP or RAS, authentication is provided in script form.
19. If your ISP or RAS uses Point-to-Point Protocol (PPP), click the Password field in the
Authentication group and enter your password. If SLIP protocol is used by your ISP or RAS,
authentication is provided in script form.
20. Depending on your default configuration, the US Parameters group or the Europe Parameters
group will be active.
If the US Parameters group is active, enter the Data SPID supplied by your local phone
company which you recorded in Before You Start Loading Your Software.
21. Click the OK button to continue loading your software.
22 MTPSR1-202ST