Table of Contents
Advertisement
ProxyServer User Guide
The Message Printing Control group is used to flag specific items for generating messages on
various conditions, including Printing, Alarm, NCP (NetWare Core Protocol), and LCP (Link Control
Protocol) messages. These messages can be useful as troubleshooting tools; however, it is
recommended that under normal circumstances all items should be disabled to avoid degradation of
ProxyServer performance.
If the Need to dial out initially option is enabled (default) the ProxyServer will dial the phone
number entered in the Dial Number window upon start up. If this option is disabled, then the
ProxyServer will wait to dial until the first dial request has been made.
The Echo Request group allows you to configure the Link Control Protocol (LCP) Echo Request
parameters. Options include Maximum Number of unacknowledged LCP Echo requests allowed
before triggering the termination of the link to the peer (valid range is 1 to 20 with a default of 6
requests) and Send Interval defines the interval that the LCP will insert between two consecutive
LCP Echo Requests (valid range is 0 to 65535 with a default 0 seconds).
The Termination Request group allows you to configure the Link Control Protocol (LCP) Termination
Request parameters. Options include Maximum Number of LCP Termination Requests issued after
the completion of a back-off interval (valid range is 1 to 20 with a default of 10 requests); and, Send
Interval Max defining the interval that the LCP will insert between two consecutive LCP Termination
Requests (valid range is 5 to 65535 with a default of 5 seconds).
The Configurations Requests group allows you to configure the Link Control Protocol (LCP)
Configuration Request parameters. Options include Maximum Number of requests to be sent before
backing off due to no response (valid range is 3 to 65535 with a default setting of 6 requests); Send
Interval Max defining the interval between two consecutive LCP configuration requests (valid range is
5 to 65535 with a default of 5 seconds); and, Backoff Interval defining the interval that the LCP will
insert once the unanswered Maximum Number of Configuration requests has been reached (valid
range is 5 to 65535 with a default of 5 seconds).
38
MTPSR1-202ST
Advertisement
Table of Contents
