Table of Contents
Advertisement
ProxyServer User Guide
&E7
&E12
&E13
Command:
#Xn
Function:
Send Single/Multiple Xoff Characters
Values:
n = 0 or 1
Default:
#X0
Description:
The #X command allows the ProxyServer to send either a single or multiple Xoff
characters to exert flow control to the terminal. The #X0 command (factory default
setting) causes one Xoff to be sent until the ProxyServer's buffer reaches the Xon
level. The #X1 command causes an Xoff to be sent for every character received
after the ProxyServer reaches its buffer full level.
#X0
#X1
Command:
&Fn
Function:
Load Quick Setup Profile
Values:
n = 0–4
Default:
&F0
Description:
For quick setup, the ProxyServer includes six Quick Setup Profiles, each of which
contains configuration parameters for a specific type of port operation. You can load
a Quick Setup Profile into active memory by using the command &Fn, in which n is
the number of the profile you wish to load. You may also customize the profile and
store it, using the &W command, so that it loads automatically on power- up or reset.
These profiles are stored in permanent memory and are not user-configurable.
&F0
&F1
&F2
&F3
&F4
&F6
Command:
&Mn
Function:
Asynchronous Mode
Values:
n = 0 or 1
Default:
&M0 (Asynchronous)
Description:
Use the &Mn command to set the ProxyServer for synchronous or asynchronous
transmission. Note that synchronous transmission is not presently supported, and
this command is included for future use only.
&M0
&M1
Command:
&Rn
Function:
CTS Control
Values:
n = 0, 1, or 2
Default:
&R1 (CTS forced high)
Description:
The &Rn command lets you control the state of the CTS (Clear to Send) signal on
the RS232E/V.24 interface. Normally the CTS signal follows the state of the RTS
signal when the ProxyServer is online.
&R0
&R1
&R2
110
When XON/XOFF pacing is active, the ProxyServer responds to the XON/
XOFF characters and passes them through the communications link to the
remote device, thereby pacing the remote terminal adapter as well.
Disables pacing
Enables pacing.
One Xoff character sent until the buffer reaches the Xon level (default)
Multiple Xoff characters sent for every character received after buffer
reaches the full level.
Profile 0 — Modem-like operation (default)
Profile 1 — V.110 async operation—not presently supported.
Profile 2 — V.120 async operation—not presently supported.
Profile 3 — X.75 async operation—not presently supported.
Profile 4 — MLPPP async operation - not supported
Profile 6 — CLEAR [default = !Z=11, S52=0, and &M0 (asynchronous)]
Asynchronous mode transmission.
Synchronous mode transmission—not presently supported.
CTS acts normally; that is, it follows RTS.
CTS is forced high, but still provides online flow control.
CTS is forced high, but it drops on disconnect for the period of time set by
S10. CTS still provides flow control when the ProxyServer is online.
MTPSR1-202ST
Advertisement
Table of Contents
