Table of Contents
Advertisement
ProxyServer User Guide
S-Register:
S2
Function:
Escape Character
Unit:
Decimal ASCII code
Range:
0–127
Default:
43 (+)
Description:
S2 specifies the character used by the ProxyServer to escape from data mode and
return to command mode.
S-Register:
S3
Function:
Carriage Return Character
Unit:
Decimal ASCII code
Range:
0–127
Default:
13 (^M)
Description:
S3 specifies the character used by the ProxyServer to indicate the end of a
command line.
S-Register:
S4
Function:
Line Feed Character
Unit:
Decimal ASCII code
Range:
0–127
Default:
10 (^J)
Description:
S4 specifies the character used by the ProxyServer to indicate the end of a status
message.
S-Register:
S5
Function:
Backspace Character
Unit:
Decimal ASCII code
Range:
0–32, 127
Default:
8 (^H)
Description:
S5 specifies the character used by the ProxyServer to delete the previous character
in the command line.
S-Register:
S7
Function:
Wait for Connection (Abort Timer)
Unit:
1 second
Range:
0–255
Default:
45
Description:
S7 sets the Abort Timer delay time, which is the length of time the ProxyServer waits
for a connection after dialing. If no connection is established during the specified
time, the ProxyServer ends the call.
S-Register:
S10
Function:
DCD Drop Time
Unit:
50 ms
Range:
0–254, 255
Default:
20
Description:
S10 sets the time after a carrier signal is lost before the ProxyServer disconnects.
(The &C2 command must be in effect.) The default setting is one second. Maximum
delay is 25.4 seconds (S10=254). Set S10 to 255 to cause the ProxyServer not to
disconnect with loss of carrier.
S-Register:
S25
Function:
DTR Drop Time
Unit:
100 ms
Range:
0, 1–255
Default:
5
Description:
S25 sets the time that DTR must remain low before the ProxyServer disconnects.
The S25 unit value for 0 is 50 ms. For values from 1 through 255, the unit value is
100 ms.
116
MTPSR1-202ST
Advertisement
Table of Contents
