Reversible Flue Collar - Quadra-Fire CUMBGAP-PMH Instruction Manual

R
REVERSIBLE FLUE COLLAR
The flue collar is reversible for either a top or rear venting
installation. The unit is shipped with the flue collar in the top
vent position.
ACCESSORY HORIZONTAL FLUE SHIELD
Part HTSHLD-7006
IS REQUIRED ON ALL HORIZONTAL INSTALLATIONS.
CONVERTING COLLAR FOR REAR VENT INSTALLATION
. Lift off cast top. Remove 4 Phillips head screws from the
1
heat shield and discard heat shield. See circled areas in
Figure 10A.
2. Remove 4 Phillips head screws from the rear shield, 2
on each side, lift rear heat shield off and set aside.
3. Remove 1 bolt from each side of the flue collar using a
Phillps head screwdriver and 7/16 wrench.
4. Turn flue collar to horizontal position. Inspect sealant to
ensure a leak free application. Re-attach bolts.
5. Re-attach the rear heat shield.
6. Attach required accessory Horizontal Flue Shield with
screws provided. Figure 10B
7. Place cast top on the unit. See Figure 10C for completed
view.
Remove 4 screws and set
rear shield & screws aside
Figure 10A
Page 10
Cumberland Gap Wood Stove
Remove cast top
Remove bolts and
rotate flue collar
Discard heat
shield
Rear Heat
Shield
Figure 10B
Figure10C
7006-188E
Secure
Horizontal Flue
Heat Shield
Completed View
September 1, 2008