Outside Air Kit Installation; Optional Blower Installation - Quadra-Fire CUMBGAP-PMH Instruction Manual

Cumberland gap non-catalytic, front/side load, wood heater

Hide thumbs

Table Of Contents

Table of Contents

Included in Kit: 2 cable ties; oustide air termination cap;

mounting screws (Discard the remaining parts).

tems Needed for Installation: 4 in. (102mm) diameter ﬂex

pipe in the length as required for your installation; Phillips

screwdriver; Silicone sealant; Drills and saws necessary for

cutting holes through the wall or ﬂooring in your home.

. Remove all materials from packing box.

2. Mount the ﬂex ﬂange (with pipe ﬁtting extending out),

over the intake air opening at the rear of stove using the

four mounting screws supplied with kit.

3. Cut a 4 inch (102mm) minimum hole in the ﬂoor or wall

to accommodate outside air piping. Use 4 inch (102mm)

metal ﬂex or rigid piping to directly connect outside air to

the unit or into vented crawl space. (Do not put ﬂex into

a non-vented crawl space). If using ﬂex tubing attach

cable ties to secure tubing at both ends. Use the supplied

termination cap with a rodent screen. Seal between the

ﬂoor or wall and the pipe with silicone to prevent moisture

penetration.

The blower is shipped fully assembled and ready for installation.

Remove three Phillips head screws from rear of unit.

Using the Phillips head screws, attach blower to lower

rear of stove, as shown.

Plug blower cord into a grounded outlet. Do not remove

ground prong from plug. Route power cord to avoid

heat from the stove, or other damage. Do not route

cord under or in front of appliance.

Adjust the blower speed control to the desired speed.

*ADJUSTING THE BLOWER SPEED CONTROL,

If Necessary

When the speed control is turned clockwise, it will click

NOTE:

on to high speed. Turn the speed control clockwise to

decrease the speed. At full clockwise, the blower should

blow gently, but should not stop.

With the unit plugged in, turn the speed control knob to

slow (full clockwise).

With a small screwdriver, adjust the blower speed by

turning the adjustment mechanism through the hole on

the side of the speed control.

Adjust the speed so the blower runs slowly, but does

not stop. Turn clockwise to slow the blower and

counterclockwise to increase the speed.

September 1, 2008

Cumberland Gap Wood Stove