Removing A Hard Disk Or Media Card From The Drive Cage - HP Z200 Maintenance And Service Manual

cage. Ensure that the data cable is routed through these guides before connecting it to the optical
drive.
10. Connect the power cable (1) and data cable (2) to the rear of the optical drive.
Figure 5-19
11. Carefully rotate the drive cage back down to its normal position.
CAUTION:
Cable management on page
12.
Replace the front bezel (see
13. Replace the access panel (see
14. Restore all connections and equipment that you removed during the
on page

Removing a hard disk or media card from the drive cage

The 3.3 cm (3.5 in) drive is located underneath the 13.3 cm (5.25 in) optical drive. A media card can
also be installed at this location. If an optical drive is present, you must remove it before removing the
hard drive.
To remove a hard drive or media card from the drive cage:
1. Follow the procedures listed in the
CAUTION:
data loss.
2. Remove the access panel (see
3. Remove the front bezel (see
4.
Remove the optical disk drive if it is present. (See
ENWW
Connecting the power and data cables
Be careful not to pinch any cables or wires when rotating the drive cage down. See
106.
Installing the front bezel on page
Installing the access panel on page
69.
Failure to follow the predisassembly procedures can result in equipment damage or
Removing the access panel on page
Removing the front bezel on page
Predisassembly for drives on page 79
Removing an optical drive on page
Removing and installing components
74).
72).
Predisassembly procedures
section.
72).
74).
83.)
87