HP Z200 Maintenance And Service Manual page 96

5. Disconnect the power cable (1) and data cable (2) from the rear of the optical drive.
Figure 5-13
6. Rotate the drive cage back down to its normal position.
CAUTION:
7. Press down on the green drive retainer button located on the left side of the drive to disengage the
drive from the drive cage (1). While pressing the drive retainer button, slide the drive back until it
stops, then lift it up and out of the drive cage (2).
Figure 5-14
8. If you are replacing the drive, transfer the four guide screws from the old drive to the new one.
84 Chapter 5 Replacing components
Disconnecting the power and data cables
Be careful not to pinch any cables or wires when rotating the drive cage down.
Removing the optical drive
ENWW