Speaker; Removing The Speaker; Installing The Speaker - HP Z200 Maintenance And Service Manual

Speaker

This section describes how to remove and install the speaker.

Removing the speaker

To remove the speaker:
1. Prepare the computer for servicing by following the
CAUTION:
data loss.
2.
Remove the access panel (see
3. Remove the front bezel (see
4. Disconnect the speaker cable from the system board (1) as shown in the figure below.
5.
Remove the two screws as shown (2).
6. Slide the speaker away from the chassis and remove it from the chassis (3).
Figure 5-60

Installing the speaker

To install the speaker, reverse the previous steps.
ENWW
Failure to follow the predisassembly procedures can result in equipment damage or
Removing the access panel on page
Removing the front bezel on page
Removing the computer speaker
Predisassembly procedures on page
72).
74).
Removing and installing components
69.
113