Cisco DPC2434 User Manual page 63

How Do I Configure the Wireless Home Gateway?
To set up your password
To set up your password, type your password in the Password field, and then
re-type your password in the Re-Enter Password field. Click Apply to save your
password.
Note: If you set a password, on subsequent access to the Setup page, a screen similar
to the following appears prompting you to enter your password. Leave the user
name blank and enter your password to gain access to the Setup page. Do not forget
your password.
Configuring Network Time Synchronization
Use the Basic Settings Enable/Disable time synchronization by Network Time
protocol page to enable or disable time synchronization by Network Time protocol.
Important: Your gateway will automatically synchronize with the local time of your
DOCSIS cable network. Changes to time synchronization should only be made if the
DOCSIS network clock does not match your local time.
Note: If you are not familiar with the time configuration procedures detailed in this
section, contact your service provider before you attempt to change any of the
wireless home gateway default time synchronization configuration settings.
Click Set Time in the Basic Settings section of the Setup page to access the Basic
Settings Enable/Disable time synchronization by Network Time protocol page.
4011350 Rev D 63