Display Status - 3Com EtherLink 3C980C-TXM User Manual

60 C 4: I
HAPTER
Syntax
Example
Default

display status

This command displays information about all groups, or if a
primary slot parameter is specified, only about the specified
group. A separate message is displayed for each loaded
frame type. Board numbers are also displayed. Information
about the relationship between the board numbers and the
frame types is shown in the NetWare 5 Console Monitor.
On the Available Options screen, select LAN/WAN drivers
for this information.
Syntax
Example
C
NSTALLING AND ONFIGURING IN
lbrsl group lb addr RxIPAddr pri_slot sec_slot [sec_slot ...]
lbrsl group rsl pri_slot sec_slot [sec_slot...]
where:
lb specifies a load balancing group.
rsl specifies a resilient server link group.
RxIPAddr is a dedicated IP address for the load balancing
group
pri_slot is the PCI slot number of the primary NIC.
sec_slot is the PCI slot number of a secondary NIC.
lbrsl group lb addr 192.1.1.100 10001 10002
lbrsl group rsl 10001 10002
None
lbrsl display status [pri_slot]
where:
pri_slot is the PCI slot number of the primary NIC in the
group for which information is to be displayed. If this
parameter is not specified, information for all groups is
displayed. An example of the type of information
displayed follows:
Group NNN (LB group)
Primary board id: Original NNN, Current NNN
Load balancing on incoming IP packets: Enabled; IP Rx
Addr: NN.NN.NN.NN
Primary node address: XX:XX:XX:XX:XX:XX
Timeout values in seconds: send NNN, receive NNN,
wait NNN, link NNN
Probe Interval: NNN seconds
Slot number NNN (Active), Node Address:
XXX:XXX:XXX:XXX:XXX:XXX
lbrsl display status 10001
N W
ET ARE