Maintaining Groups - 3Com EtherLink 3C980C-TXM User Manual

11 When you have set all the configuration values,
select Save parameters and load driver.
The installation program loads the configured driver and
then writes the appropriate LOAD and BIND commands to
the AUTOEXEC.NCF file. The system assigns a network
number.
12 Enter a network number, or press Enter to select the
system-assigned number.
If no errors are encountered, the installation program asks
whether you want to select an additional network driver.
13 Continue with the installation:
If you are installing only one NIC, select No to finish loading
and exit.
If you are installing more than one NIC, select Yes to set up
another NIC.

Maintaining Groups

DynamicAccess technology server features allow you to
configure load balancing groups. The load balancing
features are described in
page
The following DynamicAccess technology server features
are available for NIC groups in NetWare:
The examples in this section illustrate typical actions you
might take in the course of maintaining a DynamicAccess
server configuration under NetWare. They show how to
add NICs and groups to a server where DynamicAccess
technology server features are already installed and
configured.
Two drivers are associated with DynamicAccess technology
server features in NetWare: SE and LBRSL.
10.
load balancing
RSL failover
Maintaining Groups
Advanced Server Features on
55