Installation And Configuration Instructions; Load The 3Com Etherlink Server Cd; Copy The Driver - 3Com EtherLink 3C980C-TXM User Manual

Installation and Configuration Instructions
With NetWare installed and the server up and running,
complete the following steps to install and configure the
driver and DynamicAccess technology server features on a
NetWare file server.
In NetWare screens, use the arrow keys to select an item
and then press Enter.

Load the 3Com EtherLink Server CD

NetWare 4.2
NetWare 5.0

Copy the Driver

1 Enter this command at the prompt:
NetWare 4.2: load install
NetWare 5.0: load nwconfig
2 In the Configuration Options screen, select
Driver options.
3 In the Driver Options screen, select
Configure network drivers.
4 In the Additional Driver Actions screen, select
Select a driver.
The Select a Driver screen appears, listing all previously
saved drivers in the system.
If this is the first installation of the 3Com server NIC driver,
it does not appear in this list.
5 Press Insert.
A system message for selecting a disk drive appears.
6 Press F3.
7 Enter a path to the volume that contains the driver.
For example:
Installation and Configuration Instructions
Insert the CD in the CD-ROM drive and enter these commands:
load cdrom
cd mount 3C980C_TXM
Insert the CD in the CD-ROM drive and enter this command:
load cdrom
Wait for the message that states the CD is mounted
successfully, and then proceed to copy the driver.
47