Configuring Groups And Vlans; Planning The Configuration - 3Com EtherLink 3C980C-TXM User Manual

32 C
HAPTER
11 Follow the installation prompts.
When the installation is finished, click Finish.
12 If you want to change SHD parameter settings,
follow these steps:
a Right-click My Network Places and select Properties
b In the next window, right-click a connection and select
c Click Configure.
d In the NIC Properties window, click the Advanced tab.
e In the Advanced window, you can configure the SHD
Configuring Groups and VLANs
DynamicAccess technology server features allow you to
configure load balancing groups and virtual LANs (VLANs).
The features are described in
page
The following DynamicAccess technology server features
are available for NIC groups in Windows:
The examples in this section illustrate typical actions you
might take in the course of maintaining a DynamicAccess
server configuration in Windows.
Planning the Configuration
Consider these items when planning groups and VLANs:
3: I
NSTALLING AND
from the menu.
Properties from the menu.
parameters. Select a parameter in the Property field and
change its value in the Value field. For parameter
descriptions, see
page 27.
10.
load balancing
RSL failover
multiple VLANs
Decide whether you want to use bidirectional load
balancing, or transmit load balancing.
To use bidirectional load balancing, you must assign a
dedicated IP address for each load balancing group. This
C W
ONFIGURING IN INDOWS
SHD Parameters (Windows) on
Advanced Server Features on