Runco LightStyle LS-12HBd Installation & Operation Manual page 24

System Overview
Runco Logo
Badge
Lamp Module
Cover
Ceiling Mount
Holes
Figure 2-3. LS-12HBd Rear/Bottom/Top View
• RUNCO LOGO BADGE
• REAR COVER
Remove to access connectors.
• LAMP MODULE COVER
Remove this cover to access the lamp compartment.
• CABLE OPENING
Pass cables through this opening.
• CEILING MOUNT HOLES
Use these to attach the ceiling bracket to the projector. Use M4 screws with a
maximum screw depth of 10 mm (0.39 inch).
• ADJUSTABLE FEET
Use these when the projector is installed in a table-top configuration to level the image
and/or adjust the projection angle.
RS232 PRIMARY SECONDARY 3D Sync Out
RS232 PRIMARY SECONDARY Out Sync 3D
8 LightStyle™ LS-12HBd Installation/Operation Manual
Rear Cover
Cable
Opening
Adjustable
Feet