Runco LightStyle LS-12HBd Installation & Operation Manual page 82

Operation
5. Press ENTER again to select Configure.
6. Select Diagnostics and press ENTER.
7. Select Blue from the Diagnostics menu, then press ENTER to display only the blue
color channel.
8. Press EXIT (or MENU) repeatedly to return to the Main Menu.
9. Select Picture from the Main Menu and press ENTER.
10.Select Color from the Picture menu and press ENTER.
11.Adjust the color saturation level until the outermost (gray and blue) color bars appear to
be a single shade of blue:
Tint: Tint or "hue" is essentially the ratio of red to green in the color portion of the image.
When tint is decreased, the image appears redder; when it is increased the image
appears greener.
To adjust the tint, enable "blue only" display mode in the Diagnostics menu, as you would
for adjusting color saturation (refer to the previous section, Color Saturation).
Select Tint from the Picture menu and press ENTER. Adjust the tint level until the cyan
and magenta color bars (on either side of the green bar) appear to be a single shade of
blue.
Like the brightness and contrast controls, the color and tint controls
Note
are interactive. A change to one may require a subtle change to the
other in order to achieve the optimum setting.
66 LightStyle™ LS-12HBd Installation/Operation Manual