Runco LightStyle LS-12HBd Installation & Operation Manual page 99

Input Names: You can give each input a descriptive name. For example, you may want
to change the default input name to the type of source component connected to it:
"VCR," "DVD," "Laptop" et cetera. Input names can be up to 12 characters long.
To edit an input name, select Input Names from the Service menu. Press
an input and press ENTER. Use the
or to select a character to change. When you have finished editing the input name,
press ENTER or MENU.
To restore the default input name, press
"Restore" column. Then, press ENTER.
Remote Control: Select Remote Control from the Service menu to set the following
options:
• Remote Code: Select Remote Code from the Remote Control menu to set the
infrared (IR) custom code (address) that the Dimension Digital Controller will accept as
valid IR data. By default, it is set to 08209 (0x2011). You can change this setting if:
• Another device in the theater (a DVD player, for example) is responding to
commands from the Dimension Digital Controller remote control (Figure 2-7) in ways
that are unpredictable or undesirable; or
• You have multiple Dimension Digital Controllers and want to control them
independently, as opposed to broadcasting commands from a single remote to all of
them. In this scenario, you can use multiple remotes programmed to use different IR
codes. Or, you can use a single remote and change the IR code as needed to
address a specific Dimension Digital Controller.
Use the Dimension Digital Controller front-panel keypad to change
Tip
the IR code to which the controller will respond. Then, change the
code sent by the remote to match as described below.
After changing the Remote Code, press EXIT to have the new code take effect.
LightStyle™ LS-12HBd Installation/Operation Manual
or buttons to change a character; press
repeatedly to highlight that input name in the
83
C o mp o s i t e
or to select
C o mp o s i t e
C o mp o s i t e
C o mp o n e n t
H D 1
H D 2
S C A R T
H D M I
H D M I
H D M I
H D M I
H D M I
H D M I
H D M I
H D M I
D i s p l a y P o r t
Operation
Input Names
Restore
1 Composite 1
2
Composite 2
3
Composite 3
Component
HD 1
HD 2
SCART
1 HDMI 1
2
HDMI 2
3
HDMI 3
4
HDMI 4
5
HDMI 5
6
HDMI 6
7
HDMI 7
8 HDMI 8
DisplayPort