Back Panel Description - Cisco DPC2203C Installation And Operation Manual

Chapter 1 Introducing the Model DPC2203C VoIP Cable Modem

Back Panel Description

The following illustration shows the description and function of the back panel
components on the DPC2203C.
Important: Do not connect your PC to both the Ethernet and USB ports at the same
time. Your modem will not function properly if both the Ethernet and USB ports are
connected to your PC at the same time.
1 POWER – Connects the cable modem to the AC power supply that is provided
with your cable modem
2 TEL 1/TEL 2 – RJ-11 telephone ports connect to home telephone wiring to
conventional telephones or fax machines
3 ETHERNET – RJ-45 Ethernet port connects to the 10/100base-T Ethernet port on
your PC or your home network
4 USB – 12 Mbps USB 1.1 port connects to the USB port on your PC
REBOOT EMTA – Pressing this switch reboots the EMTA. Pressing this switch
5
for more than three seconds resets the device to factory default values and
reboots the EMTA
6 CABLE – F-Connector connects to an active signal from your service provider
6
CAUTION:
Avoid damage to your equipment. Only use the AC power adapter that is
provided with your cable modem.
CAUTION:
The Reboot EMTA button is for maintenance purposes only. Do not use
unless instructed to do so by your service provider. Doing so may cause
you to lose any cable modem settings you have selected.
72-4017315-01 Rev B