Back Panel Description - Cisco DPC2607 User Manual

Back Panel Description

Back Panel Description
The following illustration shows the description and function of the back panel
components on the DPC2607 and EPC2607.
Important: Do not connect your PC to both the Ethernet and USB ports at the same
time. Your modem will not function properly if both the Ethernet and USB ports are
connected to your PC at the same time.
1 POWER—Connects the cable modem to the DC output of the AC power adapter
that is provided with your cable modem. Only use the AC power adapter and
power cord that is provided with your cable modem
2 TELEPHONE (1/2 and 2)—RJ-11 telephone ports connect to home telephone
wiring to conventional telephones or fax machines
3 ETHERNET 1000—RJ-45 Ethernet port connects to the GigE or 10/1000BASE-T
Ethernet port on your PC or your home network for a gigabit Ethernet
connection
4 ETHERNET 10/100—RJ-45 Ethernet port connects to the 10/100BASE-T or GigE
port on your PC or your home network for a 10/100BASE-T Ethernet connection
5 USB—USB 2.0 port connects to the USB port on your PC
6 REBOOT EMTA—Pressing this switch reboots the EMTA. Pressing this switch
for more than three seconds resets the device to factory default values and
reboots the EMTA
7 CABLE–F-Connector connects to an active signal from your service provider
14
CAUTION:
Avoid damage to your equipment. Only use the AC power adapter that is
provided with your cable modem.
CAUTION:
The Reboot EMTA button is for maintenance purposes only. Do not use
unless instructed to do so by your service provider. Doing so may cause
you to lose any cable modem settings you have selected.
4023667 Rev C