Cisco DPC2203C Installation And Operation Manual page 64

Chapter 4 Troubleshooting the Installation
Check and Correct
1 Using the Web browser on the PC attached to the cable modem, access the
WebWizard by entering the following IP address: http://192.168.100.1. The Web
browser accesses the WebWizard and the Default page opens.
2 Open the Signal page, and then select Cable Modem Status. The Cable Modem
Status list appears.
Example:
The following list shows an example of the Cable Modem Status list that you
could use to check the status of your cable modem:
notReady
notSynchronized
phySynchronized
usParametersAcquired
rangingComplete – (The cable modem should be at this status)
ipComplete
If the cable modem shows the status of rangingComplete, the cable modem has
3
a problem receiving the DHCP response from the provisioning server. In this
case, you should activate DHCP tracing on the CMTS.
If the CMTS shows the cable modem DHCP traffic, check the DHCP server for
4
possible problems.
48 72-4017315-01 Rev B