Network - TANDBERG 7000MXP User Manual

D1335403_T7000_MXP_User_Manual
Range, menu
adjustable input gain
Phantom power
voltage
Phantom power
resistor, pin 2
Phantom power
resistor, pin 3
Max phantom power
current pr mic
3 Audio Outputs:
 1 output (line level) via RCA connector providing audio from far end, in addition to dial
tones. This output also supports S/PDIF. S/PDIF (Sony/Philips Digital Interface) is used
by the Digital Natural Audio module.
 1 AUX output (line level) via RCA connector providing a mixed signal between audio from
the local side (except from the AUX input) and audio from the far end. This output is
intended for connection to a telephone add-on system. When system is configured as
stereo, this output will provide the left stereo information.
 1 VCR output (line level) via RCA connector providing a mixed signal between audio from
the local side (except from the VCR input) and audio from the far end. This output is
intended for connection to a VCR. When system is configured as stereo, this output will
provide the right stereo information.
Audio output connector specification:
Connector label
Signal type
Connector (codec)
Output impedance
Maximum output level
Minimum output level
Range, menu adjustable
output gain
Volume control attenuation
(audio out 1)

5.1.3 Network

Ethernet:
1 x Ethernet (RJ-45 Jack) LAN interface (10/100 Mb) up to 3 Mbps
To connect the system to a LAN, use the Ethernet cable provided by TANDBERG (or a standard
Ethernet cable).
The cable specification is:
1 ------------ 1
214
22.5 dB (16 steps of
1.5 dB)
24 V +/- 5%
1200 ohms
1200 ohms
12 mA
Audio outputs
Unbalanced
Female RCA/phono, sleeve-
ground, centre-signal
680 ohms
15.3 Vpp
1.15 Vpp
22.5 dB (16 steps of 1.5 dB)
0 to 21 dB + mute (steps of 1.5
dB)
22.5 dB (16 steps of
1.5 dB)
-
-
-
-