Audio - TANDBERG 7000MXP User Manual

It is possible to extend existing DVI cables by the use of extension cables. The maximum cable
length however, is 5 meters. Going beyond that may result in quality loss.
DVI-I - Combined Analog and Digital Connector Pin Assignments:
Pin Signal
Assignment
1 T.M.D.S.
Data2-
2 T.M.D.S.
Data2+
3 T.M.D.S.
Data2/4 Shield
4 T.M.D.S.
Data4-
5 T.M.D.S.
Data4+
6 DDC Clock
7 DDC Data
8 Analog Vertical
Sync
C1 Analog Red
C4 Analog
Horizontal
Sync

5.1.2 Audio

6 Audio Inputs:
 3 microphone inputs (balanced, 24V phantom powered) via XLR connectors.
 3 audio inputs (line level) via RCA connectors.
All audio inputs are active by default. For further information, refer to chapter 4.5 Audio.
Audio input connector specification:
Connector label
Signal type
Connector (codec)
Input impedance
Maximum input level
Minimum input level
Pin Signal
Assignment
9 T.M.D.S.
Data1-
10 T.M.D.S.
Data1+
11 T.M.D.S.
Data1/3 Shield
12 T.M.D.S.
Data3-
13 T.M.D.S.
Data3+
14 +5V Power
15 Ground (return
for +5V, HSync
and VSync)
16 Hot Plug Detect
C2 Analog Green
C5 Analog Ground
(analog, R, G &
B return)
Microphone(s)
Balanced
XLR-F, pin 1-gnd,
pin 2 hot, pin 3-
cold/neutral
2400 ohms (pin 2 -
3)
83 mVpp
6.2 mVpp
Pin Signal
Assignment
17 T.M.D.S. Data0-
18 T.M.D.S. Data0+
19 T.M.D.S.
Data0/5 Shield
20 T.M.D.S. Data5-
21 T.M.D.S. Data5+
22 T.M.D.S. Clock
Shield
23 T.M.D.S. Clock+
24 T.M.D.S. Clock-
C3 Analog Blue
Audio input(s)
Unbalanced
Female RCA/phono,
sleeve-ground,
centre-signal
10K ohms
15.5 Vpp
1.17 Vpp
Peripheral Equipment
213