Operation - Garmin Socata TBM850 Pilot's Manual

OPERATION

The traffic unit may be configured to automatically change from STANDBY to NORMAL mode
NOTE:
after takeoff or from NORMAL to STANDBY mode after landing. Refer to the KTA 870 Pilot's Guide for
additional operating instructions..
Selecting the STANDBY Softkey forces the unit into Standby Mode. Selecting the NORMAL Softkey allows
the KTA 870 to switch from Standby Mode to Operating Mode as necessary.
Switching from standby mode to operating mode:
On the Traffic Page, select the NORMAL Softkey.
Or:
1) Press the MENU Key and turn the small FMS knob to select Normal Mode.
2) Press the ENT Key to place the KTA 870 in the operating mode.
Switching from operating mode to standby mode:
On the Traffic Page, select the STANDBY Softkey.
Or:
1) Press the MENU Key and turn the small FMS knob to select Standby Mode.
2) Press the ENT Key to place the KTA 870 in the Standby mode.
System Self Test
1) Set the range to 2/6 nm to allow for display of full traffic test pattern.
2) Select the TEST Softkey.
3) Self test takes approximately eight seconds to complete. When completed successfully, traffic symbols are
displayed and a voice alert "TAS System Test Okay" is heard. In the event that the system test fails, the system
reverts to Standby Mode and a voice alert "TAS System Test Fail" is heard.
Displaying traffic on the Traffic Map Page:
1) Turn the large FMS Knob to select the Map Page Group.
2) Turn the small FMS Knob to select the Traffic Map Page.
3) Select the NORMAL Softkey to begin displaying traffic. OPERATING is displayed in the Traffic mode field.
4) Select the ALT MODE Softkey to change the altitude volume.
5) Select the STANDBY Softkey to place the system in the Standby mode. STANDBY is displayed in the Traffic
mode field.
6) Turn the RANGE Knob clockwise to display a larger area or counter-clockwise to display a smaller area.
190-00709-04 Rev. A Garmin G1000 Pilot's Guide for the Socata TBM 850
HAZARD AVOIDANCE
461