Setting The Tuning Step; Shift Direction And Offset Frequency Settings - Alinco DJ-175 T Instruction Manual

4.Basic Operation
Tuning step
5.0kHz
10.0kHz
12.5kHz
15.0kHz
20kHz
25kHz
30kHz
4

4.4.2 Setting the Tuning Step

1. Press the FUNC key in the VFO mode, and while
key to display the current tuning step.
2. Rotate the dial to select the desired tuning step.
STP-5
3. Press any key except for the MONI key to complete setting.
NOTE:
• Tuning step can't be changed in the Memory mode.
• When the tuning step is changed from 5kHz,10kHz,15kHz,20kHz or 30kHz to
12.5kHz and 25kHz or vice versa, the operating frequency and the shift width
automatically suit to the new setting.

4.4.3 Shift Direction and Offset Frequency Settings

In conventional repeater systems, a signal received on one frequency is retransmitted
on another frequency. The difference between these two frequencies is called the
offset frequency. The selectable offset frequency of this unit is from 0 to 99.995MHz.
1. Press the FUNC key, and while
current offset frequency and shift direction settings.
24
Entry completion digit
1kHz Accept 0 or 5 as valid number.
10kHz Accept any of 0 to 9 keys.
10kHz When you input the 10kHz digit, the 1kHz digit is
set automatically as follows.
0---00.0, 1---12.5, 2---25.0, 3---37.5, 4---invalid,
5---50.0, 6---62.5, 7---75.0, 8---87.5, 9---invalid
1kHz Accept 0 or 5 as valid number.
10kHz Auto-complete after the 10kHz digit entry.
10kHz When you input the 10kHz digit, the 1kHz digit is
set automatically as follows.
0---00.0, 2---25.0, 5---50.0, 7---75.0
Other entries are invalid.
10kHz Auto-complete after the 10kHz digit entry.
DOWN
STP-10 STP-12.5
Final digit selection
is displayed, press the
UP
STP-15 STP-20
is displayed, press the
(unit: kHz)
STP-25 STP-30
key to display the