[Entering A Frequency Directly]; [Entry Method Depending On Tuning Step] - Alinco DR-135T MkII Instruction Manual

9. Remote Control Operation

[Entering a frequency directly]

Frequencies can be entered directly by pressing the
numerical (1~0) keys.
1.
Set the microphone REMOTE / DTMF switch to the REMOTE position.
2.
DTMF keys can be used to enter ftom the 100 MHz digit.
(Ex.) When setting 144.20 MHz with the tuning step set to 5 kHz.
After entering the sixth digit a slightly longer beep is emitted and the entry is com-
plete.
3.
Cancelling an entry before it is completed. Press PTT, or any key other than the
numerical keys.

[Entry method depending on tuning step]

Depending on the set tuning step, digit entry may be necessary to the 1 kHz digit. In some cases
entry to the 10 kHz digit is sufficient. For cases in which digit entry is only necessary to the 10 kHz
digit some digit keys wre not accepted.
The relationshop between the tuning step and input method is as follows.
Tuning step
completion digit
5.0 kHz
1 kHz
8.33 kHz
10.0 kHz 10 kHz
12.5 kHz 10 kHz
15.0 kHz 10 kHz
20.0 kHz 10 kHz
25 kHz 10 kHz
30 kHz 10 kHz
50 kHz 10 kHz
40
Enter
Entry
Completion after input of the 1 kHz digit.
Completion after input of the 10 kHz digit.
When you input the 10 kHz digit, the 1 kHz digit set as follows.
0···00.0, 1···12.5, 2···25.0, 3···37.5, 4···invalid
5···50.0, 6···62.5, 7···75.0, 8···87.5, 9···invalid
Completion after input of the 10 kHz digit.
Completion after input of the 10 kHz digit.
When you input the 10 kHz digit, the 1 kHz digit set as follows.
0···00.0, 2···25.0, 5···50.0, 7···75.0,
Other entries are invalid.
When you input the 10 kHz digit, the 1 kHz digit set as follows.
When you input the 10 kHz digit, the 1 kHz digit set as follows.
0···00.0, 5···50.0
Final digit selection