Table of Contents
Advertisement
(1) STP (Frequency Tuning Step)
This menu is to set tuning step when adjusting frequency by
CLARIFIER knob.
Options: 10Hz 、100Hz 、1KHz 、10KHz
Default: 10Hz
(2) CLA (CLARIFIER knob functions setting)
This menu is to set functions turned by CLARIFIER knob. Options are
as follows:
FIN: Fine regulation. When this option is selected, users can fine
tuning the receiving frequency by rotating the CLARIFIER
knob. In tuning process, the transmitting frequency can not be
9 9
regulated by the knob and "1" icon will appear on the LCD.
RT: When this option is selected, users can regulate the frequency of
both transmitting and receiving. In tuning process, "2" icon will
appear on the LCD.
T: When this option is selected, users can only regulate the
transmitting frequency. In tuning process, "3" icon will appear on
the LCD.
Default: RT
(3) PUS (PUSH Function Setting)
This menu is to set functions realized via PUSH knob. Options are as
follows:
W
h
e
n
h t
s i
o
t p
o i
n
s i
COA:
knob to realize COARSE function.
s
e
e l
c
e t
, d
p
e r
s s
P
U
S
H
a
n
d
u t
n r
When pressing this key, "2" icon will appear on far left of the
LCD. Under this condition, rotate the CLARIFIER knob to change
frequency of both transmitting and receiving.
T: When this option is selected, press PUSH and turn CLARIFIER
knob to change transmitting frequency. When pressing this key,
"3" icon will display on the far left of the LCD. Under this condition,
rotate the CLARIFIER knob to change the transmitting frequency
only.
STP:When this option is selected, PUSH function will change
Frequency Tuning Step of CLARIFIER knob. Press this key, then
the corresponding frequency bit would blink.
Default: STP
(4)TOT (Transmitting Time-Out-Timer)
This menu is to set transmitting TOT time. When pressing PTT key
at a single time longer than the due time setup in advance, the radio
would stop transmitting automatically and loudspeaker will emit voice
prompt till PTT key is released. Then, the radio can transmit again.
Options: 30-600s Step: 30s
Default: 180s
(5) SC Scanning Type Selection
This menu is to set Scan Type. Options are as follows:
SQ: When SQ is selected, scan would stop when a valid signal
is detected. The radio would resume scanning after signal
C
L
A
R
F I
E I
R
disappears for 5s.
9
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
