Table of Contents
Advertisement
Modulation FX Parameters
16: AUTO PAN
Cyclically modulates the stereo location of the sound.
L in
Auto Pan
R in
Auto Pan
Parameter
Value
Switch
OFF, ON
Depth Knob
RATE, DEPTH
Rate Knob
TRI,
SQR,
SIN,
SAW1,
SAW2
Mod Wave
SAW1
R
L
Rate (sync sw) #
OFF, ON
0.05–10.00 [Hz]
Rate (Hz) #/
Rate (note) #
note (p. 31)
Depth #
0–127
Low Gain
-15–+15 [dB]
High Gain
-15–+15 [dB]
Level
0–127
12
L out
2-Band EQ
R out
2-Band EQ
Explanation
Turns the effect on/off.
Specifies the parameter that is
controlled by the MODULATION FX
[DEPTH] knob.
Specifies the parameter that is
controlled by the MODULATION FX
[RATE] knob.
Modulation wave
TRI: triangle wave
SQR: square wave
SIN: sine wave
SAW1/2: sawtooth wave
SAW2
R
L
If this is ON, the modulation is
synchronized to the tempo of the
rhythm (owner's manual p. 24).
Frequency of the change
Depth to which the effect is applied
Gain of the low range
Gain of the high range
Output Level
17: SLICER
By applying successive cuts to the sound, this effect turns a
conventional sound into a sound that appears to be played as a
backing phrase. This is especially effective when applied to sustain-
type sounds.
You can use MFX CONTROL to restart the step sequence from the
beginning (p. 31).
L in
Slicer
R in
Slicer
Parameter
Value
Switch
OFF, ON
Depth Knob
RATE,
ATTACK,
SHUFFLE
Rate Knob
Step 01–16
0–127
Rate (sync sw) #
OFF, ON
0.05–10.00 [Hz]
Rate (Hz) #/
Rate (note) #
note (p. 31)
Attack #
0–127
Input Sync Sw
OFF, ON
Input Sync
0–127
Threshold
LEGATO,
Mode
SLASH
Shuffle #
0–127
Level
0–127
L out
R out
Explanation
Turns the effect on/off.
Specifies the parameter that is
controlled by the MODULATION FX
[DEPTH] knob.
Specifies the parameter that is
controlled by the MODULATION FX
[RATE] knob.
Level at each step
If this is ON, the modulation is
synchronized to the tempo of the
rhythm (owner's manual p. 24).
Rate at which the 16-step sequence
will cycle
Speed at which the level changes
between steps
Specifies whether an input note
will cause the sequence to resume
from the first step of the sequence
(ON) or not (OFF)
Volume at which an input note will be
detected
Sets the manner in which the volume
changes as one step progresses to
the next.
LEGATO: The change in volume from
one step's level to the next remains
unaltered. If the level of a following
step is the same as the one preceding
it, there is no change in volume.
SLASH: The level is momentarily
set to 0 before progressing to the
level of the next step. This change
in volume occurs even if the level of
the following step is the same as the
preceding step.
Timing of volume changes in levels for
even-numbered steps (step 2, step 4,
step 6...).
The higher the value, the later the beat
progresses.
Output level
Advertisement
Table of Contents
