3Tap Pan Delay - Roland RD-800 Manual

Modulation FX Parameters

33: 3TAP PAN DELAY

Produces three delay sounds; center, left and right.
L in
Triple Tap Delay
Feedback
R in
Parameter Value
Switch OFF, ON
Depth Knob
CENTER
FEEDBACK,
BALANCE
Rate Knob
Delay Left/Right/
OFF, ON
Center (sync sw)
Delay Left/Right/
1–2600 [msec]
Center (msec) #/
Delay Left/Right/
Center (note) # note (p. 31)
Center Feedback
-98–+98 [%]
#
200–8000 [Hz],
HF Damp
BYPASS
Left/Right/
0–127
Center Level
Low Gain -15–+15 [dB]
High Gain -15–+15 [dB]
D100:0W–
Balance #
D0:100W
Level
0–127
20
Balance D
2-Band
EQ
Balance W
Left Tap
Center Tap
Balance W
Right Tap
2-Band
EQ
Balance D
Explanation
Turns the effect on/off.
Specifies the parameter that is
controlled by the MODULATION FX
[DEPTH] knob.
Specifies the parameter that is
controlled by the MODULATION FX
[RATE] knob.
If this is ON, the modulation is
synchronized to the tempo of the
rhythm (owner's manual p. 24).
Adjusts the time until the delay sound
is heard.
Adjusts the amount of the delay
sound that's fed back into the effect.
Negative "-" settings invert the phase.
Adjusts the frequency above which
sound fed back to the effect is filtered
out (BYPASS: no cut).
Volume of each delay
Gain of the low frequency range
Gain of the high frequency range
Volume balance between the direct
sound (D) and the delay sound (W)
Output Level
34: 4TAP PAN DELAY
This effect has four delays.
L in
L out
Feedback
R out
R in
2
1
L
Parameter
Switch
Depth Knob
Rate Knob
Delay 1–4 Time
(sync sw)
Delay 1–4 Time
(msec)/
Delay 1–4 Time
(note)
Delay 1
Feedback #
HF Damp
Delay 1–4 Level
Low Gain
High Gain
Balance #
Level
Balance D
Delay 1
Delay 2
Quadruple Tap Delay
Delay 3
Delay 4
Balance D
3
4
R
Value Explanation
OFF, ON Turns the effect on/off.
Specifies the parameter that is
controlled by the MODULATION FX
[DEPTH] knob.
DLY 1 FBACK,
BALANCE
Specifies the parameter that is
controlled by the MODULATION FX
[RATE] knob.
If this is ON, the modulation is
OFF, ON synchronized to the tempo of the
rhythm (owner's manual p. 24).
1–2600 [msec]
Adjusts the time until the delay 1–4
sound is heard.
note (p. 31)
Adjusts the amount of the delay
-98–+98 [%] sound that's fed back into the effect.
Negative "-" settings invert the phase.
Adjusts the frequency above which
200–8000 [Hz],
sound fed back to the effect is filtered
BYPASS
out (BYPASS: no cut).
0–127 Volume of each delay
-15–+15 [dB] Gain of the low frequency range
-15–+15 [dB] Gain of the high frequency range
D100:0W– Volume balance between the direct
D0:100W sound (D) and the delay sound (W)
0–127 Output Level
L out
Balance W
Balance W
R out