Table of Contents
Advertisement
49: OD/DS " TWAH
L in
Overdrive/
Amp
Distortion
Simulator
R in
Parameter
Value
Switch
OFF, ON
DRIVE,
Depth Knob
TONE,
TWAH SENS,
TWAH MANUAL,
TWAH PEAK,
Rate Knob
TWAH BALANCE
Drive Switch
OFF, ON
OVERDRIVE,
Drive Type
DISTORTION
Drive #
0–127
Tone #
0–127
Amp Switch
OFF, ON
SMALL,
BUILTIN,
Amp Type
2-STACK,
3-STACK
TWah Switch
OFF, ON
TWah Filter Type LPF, BPF
TWah Polarity
DOWN, UP
TWah Sens #
0–127
TWah Manual #
0–127
TWah Peak #
0–127
D100:0W–
TWah Balance #
D0:100W
Low Gain
-15–+15 [dB]
High Gain
-15–+15 [dB]
Level
0–127
L out
Touch
2-Band
Wah
EQ
R out
Explanation
Turns the effect on/off.
Specifies the parameter that is
controlled by the MODULATION FX
[DEPTH] knob.
Specifies the parameter that is
controlled by the MODULATION FX
[RATE] knob.
Turns overdrive/distortion on/off
Type of distortion
Degree of distortion
Also changes the volume.
Sound quality of the Overdrive effect
Turns the Amp Simulator on/off.
Type of guitar amp
SMALL: small amp
BUILT-IN: single-unit type amp
2-STACK: large double stack amp
3-STACK: large triple stack amp
Wah on/off
Type of filter
LPF: Produces a wah effect in a broad
frequency range.
BPF: Produces a wah effect in a narrow
frequency range.
Direction in which the filter will move
UP: Move toward a higher frequency
DOWN: Move toward a lower
frequency
Sensitivity with which the filter is
modified
Basic frequency at which the wah
effect is applied
Width of the frequency region at
which the wah effect is applied
Increasing this value will make the
frequency region narrower.
Volume balance of the sound that
passes through the wah (W) and the
direct sound (D)
Gain of the low range
Gain of the high range
Output Level
50: OD/DS " AWAH
L in
Overdrive/
Amp
Distortion
Simulator
R in
Parameter
Value
Switch
OFF, ON
DRIVE,
TONE,
Depth Knob
AUTOWAH
MANUAL,
AUTOWAH PEAK,
AUTOWAH RATE,
AUTOWAH
DEPTH,
Rate Knob
AUTOWAH
BALANCE
Drive Switch
OFF, ON
OVERDRIVE,
Drive Type
DISTORTION
Drive #
0–127
Tone #
0–127
Amp Switch
OFF, ON
SMALL,
BUILT-IN,
Amp Type
2-STACK,
3-STACK
AutoWah Switch OFF, ON
AutoWah Filter
LPF, BPF
Type
AutoWah
0–127
Manual #
AutoWah Peak #
0–127
AutoWah Rate
OFF, ON
(sync sw) #
AutoWah Rate
0.05–10.00 [Hz]
(Hz) #/
AutoWah Rate
note (p. 31)
(note) #
AutoWah Depth
0–127
#
AutoWah
D100:0W–
Balance #
D0:100W
Low Gain
-15–+15 [dB]
High Gain
-15–+15 [dB]
Level
0–127
Modulation FX Parameters
Auto
2-Band
Wah
EQ
Explanation
Turns the effect on/off.
Specifies the parameter that is
controlled by the MODULATION FX
[DEPTH] knob.
Specifies the parameter that is
controlled by the MODULATION FX
[RATE] knob.
Overdrive/distortion on/off
Type of distortion
Degree of distortion
Also changes the volume.
Sound quality of the Overdrive effect
Turns the Amp Simulator on/off.
Type of guitar amp
SMALL: small amp
BUILT-IN: single-unit type amp
2-STACK: large double stack amp
3-STACK: large triple stack amp
Wah on/off
Type of filter
LPF: Produces a wah effect in a broad
frequency range.
BPF: Produces a wah effect in a narrow
frequency range.
Basic frequency at which the wah
effect is applied
Width of the frequency region at
which the wah effect is applied
Increasing this value will make the
frequency region narrower.
If this is ON, the modulation is
synchronized to the tempo of the
rhythm (owner's manual p. 24).
Rate at which the wah effect is
modulated
Depth at which the wah effect is
modulated
Volume balance of the sound that
passes through the wah (W) and the
direct sound (D)
Gain of the low range
Gain of the high range
Output Level
L out
R out
27
Advertisement
Table of Contents
