Entering Settings - imagistics sx1480 Manual

Entering settings

The following table lists the settings should be set when the second
phone line (Line 2) has been installed. You can set these settings by
using the User install mode described from page 1-3.
Settings
Comm. Line type
(Phone type)
Dial Tone detection
TTI (Transfer Terminal
Identifier)
Default TTI
(Usual TTI)
TTI Number
(Your fax number)
Transmit Line Mode
(Line Mode)
Tx/Rx
PSTN/PBX
(Line Type)
NOTE: Regarding the fax reception mode, you can select either Fax ready, Fax/
Tel ready, Tel/Fax ready, Ans./Fax ready or Tel ready for the Line 1 only.
For the Line 2, it is fixed to Fax Ready and you cannot change it.
1-2
Description
Set the appropriate dialing type needed for
the fax machine, either "Tone" or "Pulse".
If you select "On", the machine does not
dial until it detects a dial tone from the
exchanger with which the machine is con-
nected. However, there is a situation the
machine may not dial although it acquires a
dial tone because it is difficult to correspond
to all of various dial tones. In this case, turn
off the dial tone detection.
Three types of sender names can be regis-
tered, each containing up to 22 characters.
Select the TTI that will be used most often.
The selected TTI will be printed at the top of
every page you send with your fax number.
The registered fax number will be printed at
the top of every page you send with the stan-
dard TTI. Up to 20 digits can be registered.
Select according to your usage requirement.
When you choose "Auto Select", the machine
will select the line automatically for all
transmissions.
When you choose "Manual Select", you can
select the line for each transmission.
Select either "Tx/Rx (sending and receiv-
ing)", "Rx (receive only)" or "Tx (transmission
only)" to determine how the telephone line
will be used.
Select the line type from "PSTN" or "PBX".
When the line is connected to outside line
directly, select "PSTN".
When the line is connected to an extension
exchanger, select "PBX".