For sx1480 users
By "User Install mode", you can set continuously the settings that
should be set when the second phone line (Line 2) has been installed.
If you press [Reset] during setting up, the machine returns to
Standby mode. But it will keep the settings you saved by pressing
[Enter].
To start the User Install mode:
1
Press [Menu], [9].
[Program]
9 User Install
q Dial tone detection setting
2
Press [Enter] repeatedly until the following display appears.
DialTone Detect1:Off
3
Press [
press [Enter] to save the setting.
If you select [ON], the machine does not dial until it detects a dial
NOTE:
tone from the exchanger with which the machine is connected.
However, there is a situation the machine may not dial although it
acquires a dial tone because it is difficult to correspond to all of vari-
ous dial tones. In this case, turn off the dial tone detection.
4
Press [
press [Enter] to save the setting.
DialTone Detect2:Off
q Transmit line mode setting
The machine asks you to determine whether the telephone line
should be chosen automatically or manually.
5
Press [
to save the setting.
Line Mode
1-12
No.9
6
5
/
/Enter
] or [
] to select "On" or "Off " for the Line 1, then
] or [
] to select "On" or "Off " for the Line 2, then
6
5
/
/Enter
] or [
] to select "Auto" or "Manual", then press [Enter]
:Auto
6
5
/
/Enter