Table of Contents
Advertisement
MICROBOARDS TECHNOLOGY, LLC
Installing Ink Cartridges and Print Heads
Supported Ink Cartridges
The MX Disc Publisher uses 3 color and 1 black ink cartridges.
cartridges are PFP-HC-CYAN, PFP-HC-MAGENTA, PFP-HC-YELLOW, and PFP-HC-BLACK.
other cartridges are installed, the MX Disc Publisher will not function. These cartridges are available
from any Microboards reseller.
Refill kits or non-Microboards ink cartridges are not recommended for use in the MX Disc
Publisher system. Use of non-Microboards cartridges will cause the printer to fail. Use of
Loading / Replacing Ink Cartridges
Cartridges can be changed while the MX Disc Publisher is on, but it should never be turned on
without an ink cartridge in place. An LED will light above any cartridge that needs to be replaced.
•
Lower the ink door.
•
If replacing an empty ink cartridge, remove the color
that needs changing by pulling straight out.
•
Remove each new print cartridge to be installed from
its packaging.
•
Slide the correct ink cartridge into the correct slot with
the arrows pointing down, as shown to the right.
•
Raise the ink door and latch it back into place. The
printer will be ready after the ink cartridges pressurize
and the Media Feed button LED goes out.
Installing / Replacing Printheads
The 2 Printheads are not installed when you receive the MX Disc Publisher, and must be installed
prior to using the printer. The printhead models are CG316A (yellow and black) and C9382A (cyan
and magenta).
1. Raise the top Printhead Access Door.
2. If you are setting up the MX Disc Publisher for the first time, remove
any packaging materials from around the printhead carriage.
3. If you are replacing printheads and the printhead carriage is not
parked all the way to the left, turn on the MX Disc Publisher. With the
Printhead Access Door opened, press and hold the Media Feed
button until the carriage moves to the left and locks into position.
4. Lift the cradle latch.
printheads, remove the printheads by lifting the blue handle of each
and gently pulling up on each handle.
5. Remove the printheads from the packaging.
6. Gently shake each printhead 6 times prior to removing the orange
protective caps. Save the caps! If you remove the printheads from
the MX Disc Publisher, they should be recapped to avoid clogging the
printheads and ink valves.
7. Gently press the printheads into the cradle, installing the correct
printhead in the correct slot. DO NOT FORCE THE PRINTHEADS
INTO PLACE.
8. Lower the cradle latch carefully.
9. Lower the top Printhead door. The printhead carriage will return to
the right and will be primed by the printer if the power is on.
7
refilled cartridges may cause the MX Disc Publisher to fail.
If you are replacing the currently installed
MX DISC PUBLISHER
The part numbers for these
Step 4
Step 7
If
Advertisement
Table of Contents
