Diameter Settings Tab
The Diameter Settings tab allows you to
change the size of the print image to
accommodate the variety of printable
surface area available on media.
The Outer and Inner Diameters will
change the size of the area to be printed.
To avoid excessive ink buildup, these
values should never be set so that the MX
Disc Publisher is printing off the media.
The Parameter Unit should remain on the
0.1mm setting for maximum precision.
Utility Tab
The Utility tab allows you to change the printer alignment
settings.
The Resolution setting should always be set at .1mm for
best results.
Alignment values will move the print image on the disc.
Increasing the Top alignment value will move the print image down on the disc, while decreasing it
will move the image up on the disc. Increasing the Left alignment value will move the print image to
the right on the disc, while decreasing it will move the image left.
About Tab
The About tab provides you with contact information for the worldwide Microboards offices.
• Printing Preferences
14