Installing Ink Cartridges; Supported Ink Cartridges; Loading / Replacing Ink Cartridges - MicroBoards Technology G3 User Manual

MICROBOARDS TECHNOLOGY, LLC

Installing Ink Cartridges

Supported Ink Cartridges

The G3 Disc Publisher uses a single color ink cartridge. The part number for this cartridge is GX-
300HC. If other cartridges are installed, the G3 Disc Publisher will not function. These cartridges are
available from any Microboards reseller.
Refill kits or non-Microboards ink cartridges are not recommended for use in the G3
Disc Publisher system. Use of these types of cartridges will cause the printer to fail

Loading / Replacing Ink Cartridges

Cartridges should be changed while the G3 Disc Publisher is on. The cartridge can be replaced
during printing.
The G3 Disc Publisher system ships with one Microboards GX-300HC color ink cartridge.
•
Lift the front cover with the power on. The ink cartridge cradle will move to the right side of
the G3 Disc Publisher, as shown below.
•
Tilt the old cartridge forward to release the cartridge from the cradle, as shown in the inset
below.
•
Lift the old cartridge out of the cradle.
•
Remove the new GX-300HC ink cartridge from its packaging and carefully remove the plastic
tape. Hold the ink cartridge so that the copper strip is at the bottom.
•
With the front of the new GX-300HC ink cartridge tilted down, slide the cartridge into the
cradle.
•
Tilt the front of the GX-300HC ink cartridge back up to lock the ink cartridge in place.
•
Lower the front cover.
•
The new GX-300HC ink
cartridge will be initialized
by the printer.
The Microboards GX-300HC
Ink Cartridge must be used
or the printer will not
function.
7
and will void the warranty.
G3 DISC PUBLISHER