Table of Contents
Advertisement
AOC-USASLP-H8iR Add-on Card User's Guide
WebBIOS Configuration Wizard - Auto Configuration
When using either Auto Configuration setting, do the following:
1.
When prompted to review the new configuration, review the settings.
2.
Click Accept or Back to change any settings. (Auto Configuration with Redun-
dancy creates a RAID 5 configuration if at least three disks are available. If
only two disks are available, the setup creates RAID 1.)
3.
Click Yes to save the configuration, and Yes again to initialize the new virtual
disk.
WebBIOS CU will begin the initialization of the virtual drives.
WebBIOS Configuration Wizard - Custom Configuration
This section gives an overview of the WebBIOS Custom Configuraiton. When using
the Custom Configuration setting, consult the WebBIOS disk Help file and other LSI
documentation for more complete instructions.
WebBIOS Configuration
1.
The Custom Confirguration window includes two sections: Physical Drives
and Disk Groups. Press CTRL and select each ready desired physical drives
from the group. Select two drives for RAID 1 and three drives for RAID 5.
2.
Click Accept DG.
3.
For other RAID levels, repeat steps 1 and 2 and do the following: for RAID 10
configuration, create a second RAID 1 disk group. For RAID 50 confirmation,
select physical drives for a second RAID 5 disk group.
4.
Click Next when you have completed selecting drives for disk groups.
The span definition screen appears. Select one of the available disk groups
and click Add to Span and click Next.
5.
In the Virtual Disk Definition screen, set the following:
RAID Level: To create a RAID 10 (spanned), add both disk groups you cre-
ated earlier to SPAN. Then click Next and select the RAID level on the virtual
disk definition. Do the same for RAID 50 and RAID 60.
3-2
Advertisement
Table of Contents
