Table of Contents
Advertisement
4. To remove a hotspare from an array, select it in the right panel and click Remove
HotSpare.
5. Click Next.
The next Configuration Wizard window appears, as shown in Figure 6-6.
The Arrays with Free Space menus list the new array(s) that you just defined, plus
any existing arrays with holes (free space) that could be used for a new configura-
tion.
6. Select the array to use for the new virtual disk.
7. In the right panel, select RAID 1 as the RAID level.
8. (Optional) Set Size (in MB) to a lower number if you do not want to use the entire
available capacity for the new virtual disk.
9. (Optional) Change the other Virtual Disk Properties, if necessary.
10. Click Accept to accept the configuration of the new virtual disk.
Note: Click the Reclaim button if you want to undo a virtual disk that you just
defined.
11. Click Next to continue with the next configuration step.
The Virtual Disk Summary window appears.
12. Review the configuration shown in the window. If you want to change something,
click Back and change the configuration parameters.
6-11
Chapter 6: Configuration
Advertisement
Table of Contents
