Table of Contents
Advertisement
Starting the computer by password
To start up the computer with the user password, follow these steps:
1. Turn on the power as described in Chapter 3,
following message appears:
S
At this point, the hotkeys Fn + F1 to F9 do not work. They will function after
you enter the password.
2. Enter the password.
3. Press Enter.
If you enter the password incorrectly three times in a row, the computer
shuts off. In this case, you must turn the computer back on to retry
password entry.
Power-up modes
The computer has the following power-up modes:
I
Boot: Computer shuts down without saving data. Always save your
work before you turn the computer off in boot mode.
I
Hibernation Mode: Data in memory is saved to the hard disk.
I
Standby Mode: Data is maintained in the computer's main memory.
Refer also to the sections
in Chapter 3, Getting Started.
Windows utilities
You can specify the setting in TOSHIBA Power Saver.
Hot keys
You can use hot keys Fn + F3 to enter Standby Mode and Fn + F4 to enter
Hibernation Mode. Refer to Chapter 5,
User's Manual
Password =
Turning on the power
Getting
Started. The
and
Turning off the power
The Keyboard
for details.
Power
6-14
Advertisement
Table of Contents
