Table of Contents
Advertisement
Some CD/DVDs run
correctly, but others do
not
Floppy disk drive
For more information, refer to Chapter 4,
Problem
Drive does not operate There may be a faulty cable connection. Check
You cannot access the
external 3 1/2" floppy
disk drive
User's Manual
Open the drawer and make sure the CD/DVD is
properly seated. It should lie flat with the label
facing up.
A foreign object in the drawer could block laser
light from reading the CD/DVD. Make sure there
is no obstruction. Remove any foreign object.
Check whether the CD/DVD is dirty. If it is, wipe it
with a clean cloth dipped in water or a neutral
cleaner. Refer to the
Chapter 4 for details on cleaning.
The software or hardware configuration may be
causing a problem. Make sure the hardware
configuration matches your software's
needs.Check the CD/DVD's documentation.
Check the type of CD/DVD you are using. The
drive supports:
DVD-ROM:
CD-ROM:
Check the region code on the DVD. It must
match that on the DVD Super Multi drive. Region
codes are listed in the
section in Chapter 2, The Grand Tour.
Operating
Procedure
the connection to the computer and to the drive.
Try another floppy disk. If you can access the
floppy disk, the original floppy disk (not the drive)
is probably causing the problem.
If problems persist, contact your dealer.
Troubleshooting
Media care
section in
DVD-ROM, DVD-Video
CD-DA, CD-Text, Photo CD
(single/multi-session), CD-
ROM Mode 1, Mode 2, CD-
ROM XA Mode 2 (Form1,
Form2), Enhanced CD (CD-
EXTRA), Addressing
Method 2
Optical media drives
Basics.
9-10
Advertisement
Table of Contents
