Table of Contents
Advertisement
When the drawer is fully opened, the edge of the computer will extend
slightly over the CD/DVD tray. Therefore, you will need to turn the CD/DVD
at an angle when you place it in the tray. After seating the CD/DVD,
however, make sure it lies flat, as shown in figure above.
I
Do not touch the laser lens. Doing so could cause misalignment.
I
Do not allow any foreign matter or debris to enter the drive. Check the
drive tray to ensure that it is clean before you close it. Any form of dirt
contaminant that enters the drive can cause problems reading or
wirting to media, or can damage the drive.
4. Press gently at the centre of the CD/DVD until you feel it click into
place. The CD/DVD should lie below the top of the spindle, flush with
the spindle base.
5. Push the centre of the drawer to close it. Press gently until it locks into
place.
If the CD/DVD is not seated properly when the drawer is closed, the CD/
DVD might be damaged. Also, the drawer might not open fully when you
press the eject button.
User's Manual
Closing the CD/DVD drawer
Operating Basics
4-5
Advertisement
Table of Contents
