Installing memory module
To install a memory module, make sure the computer is in boot mode
then:
1. Turn the computer off in boot mode. Refer to the Turning off the
power section in Chapter 3, Getting Started.
2. Remove all cables connected to the computer.
3. Turn the computer upside down and remove the battery pack (refer to
Chapter 6, Power and Power-Up Modes.)
4. Slide the display latch on the front of the computer to the right and
open the display panel.
5. Slip your finger under a notch at the end of the keyboard brace and lift
up to release latches and remove the brace.
6. Remove two screws securing the keyboard.
Use a point size 0 Phillips screwdriver.
Portégé M100
Removing the keyboard brace
Removing two screws
Optional Devices
8-7