Toshiba B-SA4TP SERIES Owner's Manual page 26

2. PRINTER SETUP
2.4 Loading the Ribbon
(Cont.)
NOTES:
1. Be sure to remove any slack in
the ribbon when printing.
Printing with a wrinkled ribbon
will lower the print quality.
2. When a ribbon end is detected,
"RIBBON ERROR" message
will appear on the display and
the ERROR LED will illuminate.
3. When disposing of the ribbons,
please follow the local rules.
4. For the specification of
available ribbon, refer to
Section 7.2 Ribbon.
3. Lower the Top Cover to its 45
the Top Cover Stopper, raise the Top Cover again. This will fix the
Top Cover.
Top Cover
Stopper
4. Open the Ribbon Cover.
5. Fit the ribbon take-up core into the Ribbon Holder (Take-up side),
aligning the notch of the ribbon core with the protrusion of the Ribbon
Stopper.
6. Turn the ribbon take-up core in the direction indicated by the arrow to
remove any slack.
E2-12
ENGLISH VERSION EO1-33048
2.4 Loading the Ribbon
°
angle open position. While pushing
45°
Ribbon Cover
Ribbon Holder
(Take-up side)
Top Cover