Toshiba B-SA4TP SERIES Owner's Manual page 109

7. SUPPLY SPECIFICATIONS
ENGLISH VERSION EO1-33048
7.1 Media
Example 3) Rafsec Short Dipole 2 (short-pitch tag)
A Shield Sheet is supplied with the B-SA704-RFID-U2-EU-R to enable the RFID kit to encode short-pitch tags
properly. When the Shield Sheet is attached to the printer, the write field will be narrower.
The RFID kit is designed so that the second label is positioned just above the antenna while the first label is at
the print start position, when using the following short-pitch label.
5mm
20mm
(2) Storage of RFID Supplies
Do not store RFID tags close to printers, or their communication performance may not be as specified when
they are used.
(3) Roll-type RFID Supplies
When RFID supplies are to be rolled, roll hardness must be concerned.
Although it depends on the type of glue, tag, and backing paper, RFID-tag embedded labels tend to stay rolled.
Especially, when they are wound outside, a paper jam error may occur. Unless otherwise specified, it is
recommended that the RFID-tag embedded labels be wound inside.
(4) Sensor
When the transmissive sensor or reflective sensor is enabled, transmissivity or reflectivity of a label or tag may
vary at an RFID-tag embedded area depending on the pattern of an antenna or other factors. In such cases, a
manual threshold setting is required. For details, refer to Section 2.11 Threshold Setting.
(5) Cutter
When an RFID label or tag is used in cut issue mode, care must be taken not to cut an antenna of the RFID tag
or an IC chip in order not to damage the cutter.
(6) Static Electricity
When printing is performed in a place where humidity is low or under some specific conditions, writing data on
an RFID tag may fail due to static electricity generated by a label or a ribbon.
E7- 6