Setting The Clock - Sharp MD-ZV30 Operation Manual

SM <P=001>

SETTING THE CLOCK

DISC-1
1
DISC-2
2
DISC-3
3
CD PLAY
ON/STAND-BY CD
VOLUME
3D SURROUND TUNER
MODE ON/OFF (BAND)
1 2 3
TIMER /
DELETE
ON/STAND-BY
1
2
3
Date setting mode
4
5
6
7
Time setting mode
8
9
10
11
When recording, the date and time are recorded on the MiniDisc
(page 18), but only when the date and time have been previously
entered, as described in the instructions below.
TUNING
CURSOR
MD
REC
NAME / TIMER / ENTER
TRACK START TOC EDIT DELETE DISPLAY
CD MD DIGITAL EDIT
ENTER
1
2
3
4
CLOCK
DATE
CLOCK
5
6
DATE
7
CLOCK
AM
DATE
8
CLOCK
AM
DATE
CLOCK
AM
9
DATE
CLOCK
AM
10
DATE
11
CLOCK
AM
DATE
CLOCK Note:
DATE
CLOCK
Checking the date and time:
DATE
After pressing the TIMER/DELETE button, turn the jog dial until
CLOCK
the date and time are displayed.
Resetting the date and time:
See "Setting the clock".
DATE
CLOCK
DATE
ST
CLOCK
E-6
MD-ZV30H TINSZ0217AWZZ
Setting the date
Se t the ON/STAND-BY switch to ON and press the
TIMER/DELETE button.
Within 10 seconds, turn the jog dial until "TIME ADJUST"
appears.
Within 10 seconds, press the ENTER button.
The unit will enter the date setting mode.
Set the "year" using the jog dial.
When you turn the jog dial and let go, the year will change
up or down by one. When you turn and hold it, the year will
change continuously.
The year 2000 or later is set as follows:
[00] indicates the year 2000.
[01] indicates the year 2001.
Press the ENTER button to set the "year".
Set the "month" repeating steps 4 and 5.
Set the "day" repeating steps 4 and 5.
The unit will enter the date setting mode.
Set the "hour" using the jog dial.
When you turn the jog dial and let go, the hour will change
up or down by one. When you turn and hold it, the hour will
change continuously.
The clock uses the 24-hour system.
Press the ENTER button to set the "hour".
Adjust the "minute" using the jog dial.
Press the ENTER button to set the "minute".
When the ENTER button is pressed, the clock will show the
correct time.
If a power failure continues for more than 10 minutes or the
AC power lead is disconnected for more than 10 minutes,
the date and time settings will be lost.
If they are lost, set them again.
Once you have set the date and time, "TIME ADJUST" will
not be displayed in step 2. Turn the jog dial to make the date
and time appear.
If you don't need to change the settings, just press the
ENTER button without turning the jog dial again.