Sharp MD-ZV30 Operation Manual page 36

<P=004>
(Continued)
10
1
2
3
12
1
2
3
To change the programmed contents:
Turn the power on and start again from step 1.
To check the timer setting:
1
Whilst in the timer standby mode, press the
TIMER/DELETE button.
2
Turn the jog dial so that the "TIMER CALL" display
appears.
3
Within 10 seconds, press the ENTER button.
The timer settings will appear in order, and then the
original display will reappear.
To cancel the timer operation:
If the power is turned on, the timer will be cancelled.
The timer operation can also be cancelled as follows.
1
Whilst in the timer standby mode, press the
TIMER/DELETE button.
2
Turn the jog dial so that the "TIMER CANCEL" dis-
play appears.
3
Within 10 seconds, press the ENTER button.
The timer operation will be cancelled ("TIMER" or
"TIMER REC" will go off.) The start and stop times
will be stored.
Notes:
When the CD or MD is played to the end, playback
will stop before the stop time.
If you wish to play to the stop time, set repeat play
for the CD or MD.
Timer recording starts about 15 seconds before the
start time.
Caution:
In the following cases, the timer recording function will
not work
When a MiniDisc has not been inserted
When a playback-only MiniDisc is inserted
When the MiniDisc you inserted is protected against
accidental erasure
When there is no recording space left on the Mini-
Disc you have inserted (when the "TOC FULL" or
"DISC FULL" messages appear)
Function selection/volume adjustment
10
Turn the jog dial to select the function.
Timer playback
MD CD TUNER
Timer recording
TUNER AUX
If TUNER is selected, press the ENTER button then select
the preset number using the jog dial.
11
Press the ENTER button.
12
Adjust the sound level using the jog dial.
13
Press the ENTER button.
Be careful not to turn the volume up too high.
(When the start time is reached in timer playback, the volume
will increase gradually to the level previously set.)
To cancel timer setting:
Press any button other than the jog dial or the ENTER button.
Notes:
The programmed contents will remain in memory until they
are changed.
Timer playback and timer recording with this unit cannot be
used to control equipment connected to this unit. You must
use the timer of the other equipment, if it has one.
The timer playback and timer recording functions cannot be
used at the same time.
The date of timer playback or timer recording cannot be as-
signed.
Setting timer playback or timer recording
1
Press the TIMER/DELETE button.
Turn the jog dial so that the "T-STANDBY" display appears.
If the start and stop times have not been set the "T-STAND-
BY" display does not appear. Set the time.
2
Press the ENTER button.
The settings will appear in order, and the unit will enter the
timer playback or timer recording standby mode. (The power
will be turned off.)
E-34
MD-ZV30H TINSZ0217AWZZ
AUX