Table of Contents
Advertisement
Setting the clock
CD-XP120H
ENGLISH
This may be operated only with the remote control.
In this example, the clock is set for the 24-hour (0:00) display.
1 Press the ON/STAND-BY button to turn the power on.
2 Press the CLOCK button and within 8 seconds, press the
MEMORY/SET button.
3 Within 30 seconds, press the PRESET (
select 24-hour or 12-hour display and then press the MEM-
ORY/SET button.
"0:00"
The 24-hour display will appear.
(0:00 - 23:59)
"AM 12:00"
The 12-hour display will appear.
(AM 12:00 - PM 11:59)
Note that this can only be set when the unit is first installed or it
has been reset. [Refer to "Clearing all the memory (reset)" on
page 24 for details.]
E-11
4 Within 30 seconds, press the PRESET (
adjust the hour and then press the MEMORY/SET button.
! Press the PRESET (
by 1 hour. Hold it down to advance continuously.
! When the 12-hour display is selected, "AM" will change au-
tomatically to "PM".
5 Within 30 seconds, press the PRESET (
just the minutes and then press the MEMORY/SET button.
! Press the PRESET (
by 1 minute. Hold it down to advance continuously.
! The hour will not advance even if minutes advance from "59"
to "00".
To confirm the time display:
or
) button to
Press the CLOCK button.
The time display will appear for about 8 seconds.
Note:
The time will flash at the push of the CLOCK button when the AC
power supply is restored after a power failure or unplugging the unit.
Readjust the clock as follows.
To readjust the clock:
Perform "Setting the clock" from the beginning. If the time display is
flashing, step 3 (for selecting the 24-hour or 12-hour display) will be
skipped.
To change the 24-hour or 12-hour display:
1 Clear all the programmed contents. [Refer to "Clearing all the
memory (reset)" on page 24 for details.]
2 Perform "Setting the clock" from the beginning.
02/4/15
CD-XP120H(H)E2.fm
or
) button to
or
) button once to advance the time
or
) button to ad-
or
) button once to advance the time
Advertisement
Table of Contents
