Setting The Clock (Remote Control Only) - Sharp CP-BH250 Operation Manual

Setting the clock (Remote control only)

RRMCGA409AWSA
In this example, the clock is set for the 12-hour (AM 12:00)
display.
Press the ON/STANDBY button to turn the power on.
1
Press the CLOCK button.
2
Within 10 seconds, press the ENTER button. To adjust
3
the day, press the
press the ENTER button.
Press the
4
or
or 12-hour display and then press the ENTER button.
The 12-hour display will appear.
(AM 12:00 - PM 11:59)
The 12-hour display will appear.
(AM 0:00 - PM 11:59)
The 24-hour display will appear.
(0:00 - 23:59)
button and then
or
button to select 24-hour
To adjust the hour, press the
5
and then press the ENTER button. Press the
button once to advance the time by 1 hour. Hold
it down to advance continuously.
To adjust the minutes, press the
6
ton and then press the ENTER button. Press the
button once to advance the time by 1 minute.
or
Hold it down to advance the time by 5 minutes interval.
To confirm the time display:
Press the CLOCK button. The time display will appear for
about 5 seconds.
Note:
When power supply is restored after unit is plugged in again
or after a power failure, reset the clock.
To readjust the clock:
Perform "Setting the clock" from step 1.
To change the 24-hour or 12-hour display:
Clear all the programmed contents. [Refer to "Factory
1
reset, clearing all memory" on page 19 for details.]
Perform "Setting the clock" from step 1 onward.
2
E-16
button
or
or
but-
or