Positioning In The Counter Top - Smeg Hob Instructions For The User

Instructions for the installer

7. POSITIONING IN THE COUNTER TOP

The following operation requires building and/or carpentry work so must be
carried out by a competent tradesman.
Installation can be carried out on various materials such as masonry, metal,
solid wood or plastic laminated wood as long as they are heat resistant (T 90°C).
7.1 Fixing to the supporting structure
Create an opening with the dimensions shown in the figure in the top surface of
the counter, keeping a minimum distance of 50 mm from the rear edge. This
appliance can be mounted against walls higher than the work surface on
condition that a distance of "X" be kept between the appliance and the wall as
shown in the figure so as to avoid damage from overheating. Make sure that
there is a minimum distance of 750 mm between the hob and any shelf that may
be installed directly above it.
Do not use aggressive products containing alcohol or products for cleaning steel
and glass when cleaning the knobs, as these products could cause permanent
damage.
If installing over an empty kitchen unit with doors, a separation panel must be
placed under the hob. Keep a minimum distance of 10 mm between the bottom
of the appliance and the surface of the panel, which must be easily extractable
to allow sufficient access for any technical assistance.
16