Table of Contents
Advertisement
7. POSITIONING IN THE COUNTER TOP
The following operation requires building and/or carpentry work and must be
carried out by a competent tradesman.
Installation can be carried out on various materials such as masonry, metal,
solid wood or plastic laminated wood as long as they are heat resistant (T
90°C).
7.1
Fixing to the supporting structure
Create an opening with the dimensions shown in the figure in the top surface of
the counter, keeping a minimum distance of 50 mm from the rear edge. This
appliance can be mounted against walls higher than the work surface on
condition that a distance be kept between the appliance and the wall as shown
in the figure so as to avoid damage from overheating. Make sure there is a
minimum distance of 750 mm between the hob burners and any shelf or hood
that may be installed directly above it.
7.2
Hob seal
To prevent leakage of liquid between
the frame of the hob and the work
surface, place the seal provided along
the entire outer edge of the hob before
assembly.
Do not fix the hob using silicon as this would make it impossible to remove the
hob, if necessary, without damaging it.
44
Instructions for the installer
4-burner hob
5-burner hob
Advertisement
Table of Contents
