Siemens Gigaset M451 T CI Manual page 25

Installing the CA Module and Smart Card
You can install or remove CA modules online.
5. Wait until the smart card is recognised and registered by your set-top box.
This process may take a few seconds. The programmes for the channels subscribed
to with this smart card are then decrypted automatically.
Changing the Settings of a CA Module
CA modules generally have their own software as well as adjustable settings for the CRT
display. The name of the installed CA module or the inserted smart card is added to the
Settings > Common Interface menu as a new menu option following installation. You
can adapt the settings displayed in this new sub-menu to your requirements.
M
> Settings > Common Interface
w o
Choose and confirm the desired CA module and the required smart card.
Then change the desired options, if available. Please also note the infor-
mation you received with your CA module.
Starting Up the Set-Top Box
1. Note the installation instructions that
you received with your smart card or
your CA module.
2. Hold the CR module such that its con-
nections point to the CI slot on your
set-top box.
3. Push the CA module carefully into the
CI slot of your set-top box until the con-
tacts of the CA module click audibly
into place with a slight push.
4. Push the smart card into the associated
CA module until it reaches a stop. Refer
to the manufacturer's instructions re-
garding the correct direction for
insertion.
23