Controlling External Midi Devices From The Electone - Yamaha Electone Stagea ELS-01 Owner's Manual

To adjust the volume/reverb:
1
Press the [UTILITY] button on the panel to call up the Utility
display.
2
Using the MIC. REVERB and VOLUME sliders in the GLOBAL
Page, adjust the amount of the reverb applied to the microphone,
and the volume.
No sound from the microphone can be heard even though you raise the volume
here, unless you turn the INPUT VOLUME knob to the right. Similarly, no
reverb can be heard even though you raise the reverb level here, unless you raise
the total reverb level with the panel REVERB button.

Controlling External MIDI Devices from the Electone

● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ●
You can use the Electone to remotely play the Voices of a MIDI keyboard (or tone
generator), combining them with the Electone and letting you create even richer, more
multi-layered sound textures. (The MIDI receive channels of the MIDI keyboard must
match the transmit channels on your Electone.)
The Electone transmits as digital data a variety of performance messages along with
note information, including values that indicate how far the expression pedal is pressed
down and how hard you play the keyboard. How the connected external device
responds to these messages depends on the particular device.
Tone generator
MIDI IN
MIDI OUT
MIDI cable
MIDI messages
Reference Page
Reverb (page 46)
Reference Page
What is MIDI? (page 218)
NOTE
When you are using the
M.D.R., MIDI data cannot be
transmitted.
ELS-01/01C Owner's Manual
1 3
215